Meta
Deutsch francais english Using the sample loom
Home > Price list > Sample loom > photos
unscrew the bolt on each side
and turn the beater upright
a 40 cm wider reed is possible
assembling the loom:
unscrew the bolts with a 4 mm Allen key
put the castle with harnesses upright
and tighten with 4 bolts
the parts of the floor stand
the loom can be fixed with 2 hooks
assemble the floor stand with the hex key number 4
and a flat key nr 10
On the left side you can turn the little front lath, to pick out a harness.
Beat with a little hammer the wooden end of the shaft, pull off the rope and put heddles on it.
If the tie-up cords need to be connected:
pull the cord of the front harness through the left hole with a hook, then from left to right
through the hole of the lever, and pull the loop around the lever. Continue with the other harnesses.
With the even levers, insert the cord through the hole from right to left.
to fold the loom: revise the bolts and turn
the beater horizontally. Revise the bolts on the castle with shafts
and tighten it with 2 bolts in the other position.