Little loom 'Junior' 30 cm weaving width, 4 harnesses Home > Price list > Junior > photos
	Home overview...	Looms	Weaving accessories shuttles, reeds, heddles, warping frame...	Spinning wheels handards, drumcarders, wool, flax...	Weaving yarn coton, cotolinen, chenille...
Price list Weaving frame Junior Sample loom Table loom Treadling stand Dobby Foldable loom Loom bench Manuals	assembly of the loom turn the loom upside down: a little warping frame the warp: make the first thread go back for the second thread start an other color the warp is ready bundle the warp threads and put the lease sticks in the warp cross insert the warp rod in the loop at the end tie the rod to the warpbeam spread the threads along the desired width start warping (winding on the warp beam) using a raddle when warping gives better results disassemble the harness with a small hammer (the side with the black mark) then you can add heddles cut the loops at the end of the warp ready for threading put a little tension on the threads look at the warp cross for the first thread insert the first warp end in the first heddle insert the fourth warp end tie the yarn in small bunches at intervals this keeps the warp from sliding out of the heddles threading is ready sley the reed tie the threads on the second rod tighten the threads for equal tension and tie in a second knot lift the 1th and 3th harness check for threading errors pass the shuttle through the shed (gap between the threads) press the weft pick to the rod with the beater lift the 2th and 4th harness try other weft colors